https://fayettevillearsenal.com/badges.php
- Crescent.png (51.43 KiB) Viewed 28624 times
- crescent-before-after.png (202.68 KiB) Viewed 28651 times
1898, Mass Arms Co., H&D Folsom, Crescent Fire Arms Co - Single Barrel Shotgun
Re: OPEN - 0007 - Mass Arms Co., H&D Folsom, Crescent Fire Arms Co - Single Barrel Shotgun
We cleaned up the receiver and barrel bluing and we're calling this one done for now. This was a fun project. We learned a lot and we even earned a new Crescent badge. Woohoo!
https://fayettevillearsenal.com/badges.php
Now we just need to take her out and shoot. More to come...
https://fayettevillearsenal.com/badges.php
Now we just need to take her out and shoot. More to come...
Re: 1898, Mass Arms Co., H&D Folsom, Crescent Fire Arms Co - Single Barrel Shotgun
Making Shotgun Ejector and other Small Compression Springs
Intricate methods for crafting compression springs aren't necessary for this particular size and wire thickness.
When dealing with small-diameter music wire, I suggest selecting a steel rod that matches the desired inner diameter of the spring. While I've previously used elaborate screw-based jigs (which you can find tutorials for on YouTube), I've found that for small, narrow-diameter springs, a simpler approach works best. Secure one end of the wire to a steel bar held in a vise, then carefully wrap and attach the other end to a short piece of wood dowel (2-3 inches long, with a hole drilled through its center). Without using a jig or applying heat, picture the proper circular motion in your mind to keep the wire's tension fairly uniform. Gradually pull and wind the wire around the bar to the length you need. For easiest removal, work at the end of an upright, lubricated bar stock—I usually manage to twist it in a way that it catches and unwinds itself from the rod when turned.
Intricate methods for crafting compression springs aren't necessary for this particular size and wire thickness.
When dealing with small-diameter music wire, I suggest selecting a steel rod that matches the desired inner diameter of the spring. While I've previously used elaborate screw-based jigs (which you can find tutorials for on YouTube), I've found that for small, narrow-diameter springs, a simpler approach works best. Secure one end of the wire to a steel bar held in a vise, then carefully wrap and attach the other end to a short piece of wood dowel (2-3 inches long, with a hole drilled through its center). Without using a jig or applying heat, picture the proper circular motion in your mind to keep the wire's tension fairly uniform. Gradually pull and wind the wire around the bar to the length you need. For easiest removal, work at the end of an upright, lubricated bar stock—I usually manage to twist it in a way that it catches and unwinds itself from the rod when turned.
- jcastaway-small-diameter-compression-spring.png (996.96 KiB) Viewed 23368 times